Electronic Rat Trap

How To Use

1. Using a plastic or wooden knife insert a small amount of bait through the bottom hole of the back plate.
2. Insert the 4 C Batteries into the battery compartment or use the mains adaptor DC-6v.
3. Identify the area that rats have been active in, ideally a run. Place the unit on the floor against a wall, with the entrance in-line with the trail.
4. Press the switch to the on position. Unit will hum and the green light will flash, then the red light will flash indicating the unit has been enabled.
5. After a successful killing turn the switch to off and dispose of the dead rat.
6. Always read the enclosed instructions before using this rat trap.